Chapel and Dining Room Audio: Microphones Staff Can Operate

The Sunday service starts in ten minutes, the visiting pastor taps the microphone, and nothing happens. The one maintenance employee who understands the sound board is off today. Somebody pushes buttons at random, the speakers shriek, and residents in the front row cover their ears.

A sound system that only one person can run is a risk. It does not have to be complicated. The goal is a setup that a new activity assistant can operate after a two-minute read of a card on the wall.

Make the system as simple as the room allows

Start by asking what the system needs to do. Usually it is a handful of things: one or two microphones, a way to play music or a recording, and speakers that cover the room. If there is a large mixer with dozens of knobs and only three are ever used, think about replacing or simplifying it.

Options that make life easier include a mixer with its settings locked or covered, a plain wall-mounted volume control, and a system that powers on from one switch. Set the levels once, with help, when the room is quiet and then full, and mark them.

A good principle: staff should only have to touch the power switch, the volume knob for each microphone, and the music source. Everything else is set and left alone.

Label everything in plain words

Labels do more than training. Use a label maker or printed tape on each control, in words people use: "Pastor microphone," "Choir microphone," "Music player," "Main volume." Mark the normal position of each knob with a line of tape or a dot, so someone can tell when a control has been bumped.

Post a one-page card near the equipment with the steps in order:

Turn on the power strip.

Turn on the mixer or amplifier.

Turn on the microphones and check for a green light.

Raise the main volume slowly to the marked spot.

Test by speaking from where the speaker will stand.

At the end, turn everything off in reverse order.

Turning things on and off in the right order prevents pops that can startle residents and damage speakers.

Batteries, spares and charging

Wireless microphones fail most often because of weak batteries. Decide on a routine: new batteries before each service or program, or a charging base that holds rechargeable ones overnight. Mark the date on the battery compartment cover or keep a log.

Keep a small box near the equipment with:

spare batteries sized for the microphones,

a spare wired microphone and cable as a backup,

a spare cable for the music source,

a flashlight and tape,

the card with the steps and the number to call for help.

Check the box monthly. A box that was full a year ago may be empty today because someone borrowed from it.

Fixing feedback, the shriek in the speakers

Feedback happens when a microphone picks up the sound from the speaker and sends it around again. The usual causes are simple. The microphone is too close to a speaker, the volume is too high, or the speaker is pointed at the microphone.

Quick fixes:

Lower the volume for that microphone.

Move the speaker or the person away from each other so the microphone is behind the speakers, not in front of them.

Ask the speaker to hold the microphone closer to the mouth, which lets you lower the volume.

Turn off microphones nobody is using, since open microphones add noise.

If feedback returns after you have moved things, the room may be bouncing sound. A rug, curtain or wall panel can help.

Fixing a dead microphone

When a microphone is silent, work from the simple to the complex:

Check that it is switched on and the battery is fresh.

Check that its volume on the mixer is up and it is not muted.

Check that the receiver or base unit is powered and the light shows a signal.

Try the spare microphone. If it works, the first one is the problem.

Check cables at both ends and press them in firmly.

If none of this works, turn the system off and on in order, then call for help.

Write down what you tried when you call, since that saves time.

How we can help

UnityCare IT can look at your chapel or dining room sound setup, simplify the controls, label them and write a one-page card staff can follow. We can also help with microphones that drop out, and connect the system to a computer or Wi-Fi if you stream services for families.

Related service

A helpdesk your staff can call or text when something stops working.

Related articles

Keep reading

Contact UnityCare Technologies

Call or text: 405-285-3845

New customers: start@unitycareit.com

Existing customers: support@unitycareit.com

Service area: based in Edmond, Oklahoma, serving Oklahoma, Texas and Kansas

Hours: Mon–Fri 8 AM–5 PM CT; 24/7 after-hours support