A badge reader on the wall of the memory care wing looks simple: a small box with a light on it. But if the door will not unlock at shift change, the problem is rarely the reader. It is something behind the wall, in the ceiling or in a closet down the hall that nobody has opened in two years.
Understanding what is back there helps you ask better questions of a contractor and track down failures faster. It also clarifies where electricians, low-voltage installers, the fire alarm company and IT each have a part.
A typical controlled door involves several pieces.
The reader, which reads the badge or code. It is the visible part and holds almost no decision-making.
The controller, usually a panel in a closet or above a ceiling, which holds the list of who can go where and when. It decides whether to unlock.
The lock, commonly an electric strike or a magnetic lock, and sometimes an electrified latch or a lock built into the hardware.
A request-to-exit device, such as a motion sensor or push button, so someone leaving does not trigger an alarm.
A door position sensor, which reports whether the door is open or closed.
A power supply, often with a battery, which feeds the locks and the controller.
Controllers are frequently shared. One panel may serve several doors, so a failure in one panel can affect an entire wing.
Each door needs several cables: one for the reader, one for the lock power, one or two for the sensors. The cable types and gauges differ, and the lengths matter because power drops over long runs. This is why a door added "just down the hall" can cost more than expected.
Two points deserve attention:
Fail-safe versus fail-secure. A fail-safe lock unlocks when it loses power, while a fail-secure lock stays locked. Which type is appropriate depends on the door and on life-safety rules, and the choice needs to be made deliberately.
Egress and fire. Doors that people must be able to leave in an emergency are governed by fire and life-safety codes, and doors that hold residents, such as in a memory care unit, often involve delayed egress and a link to the fire alarm that releases them. These designs must be approved by the fire marshal or other authority where you operate. Do not rely on a contractor's assurance alone. Ask who is pulling permits and who signs off.
Modern controllers connect to the building network so that an administrator can add and remove badges and see door history from a computer. Typically each controller needs:
A wired network port on a switch, sometimes with power supplied over the network cable for smaller units.
A fixed address or a reservation so the management software always finds it.
A separate network segment, so the door system is not on the same network as charting and guest devices.
Backup power for the controller and the network gear it depends on.
Changed default passwords and a plan for software updates.
Many systems keep working if the network goes down. The controller remembers its list and keeps opening doors for known badges, though new badges may not be added and event logs may not be uploaded until the connection returns. Ask the installer exactly what happens during an outage, and test it.
Which panel serves each door, and what else is affected if it fails?
Are the locks fail-safe or fail-secure, and who approved that?
How do the doors behave when the fire alarm sounds?
What happens during a power loss, and how long will the battery last?
Who removes a badge when someone leaves, and how quickly can it be done?
Where is the documentation for the wiring and the panel locations?
Keep the answers somewhere your successor can find them.
UnityCare IT handles the network side of door access and camera systems in Oklahoma, Texas and Kansas, including switch ports, power over the network cable, separate segments and monitoring. We coordinate with your door and fire alarm contractors rather than replacing them. Fire and life-safety approvals remain with the authorities and licensed contractors.
Wi-Fi, switching, firewalls and internet that hold up across a whole facility.
Call or text: 405-285-3845
New customers: start@unitycareit.com
Existing customers: support@unitycareit.com
Service area: based in Edmond, Oklahoma, serving Oklahoma, Texas and Kansas
Hours: Mon–Fri 8 AM–5 PM CT; 24/7 after-hours support