An older building has a wing that was built long before anyone thought about network cable. The walls are block, the ceiling above the corridor is solid, and pulling new wire to six resident rooms means opening walls and moving residents. Yet each of those rooms has a coax outlet, put there for cable television decades ago.
That existing coax can sometimes carry network traffic, and for the right rooms it is a reasonable way to avoid demolition.
Coax is the round cable with a threaded connector used for television. It has plenty of capacity, and standards exist for sending ethernet over it. The usual approach uses a pair of small adapters. One sits at the equipment closet, where the coax from the rooms comes together, and one sits in each room. The adapters turn the network signal into a form that travels on the coax, and back to ethernet at the other end.
It is a way to make use of existing wire, not a new kind of network. Behind the adapters, the rest of your network is unchanged.
Several technologies do this, from different vendors, and they are not all compatible with each other. Your IT provider should choose a matched set.
A resident room that needs one or two connections for a TV, a phone or a sensor.
A room where an access point would improve coverage and the ceiling cannot be opened.
Offices in an older wing that need network access without new walls.
Temporary or interim use while a longer renovation is planned.
It is a practical fit for modest use. It is not meant to replace a new cabling plan for demanding applications.
Adapters can often deliver fast connections, but the real speed depends on the quality of the existing cable, its age and the number of splitters. You should expect results below the headline number on the box, and results that differ from room to room.
Also, the speed on a shared run may be divided among the rooms connected to it, depending on the technology. Ask the installer what a typical connection will deliver, and test a room before committing to all of them.
Because old coax often has several problems, a short test helps. If the cable fails in one room, you want to know before you buy for fifty.
Cables go back to a single point. A home-run layout, where each outlet has its own cable to a closet, works best. Trunk-and-branch wiring with many splitters is trickier.
Connectors and splitters are in good shape. Corroded or loose connectors cause trouble, and may need replacing.
The coax is not still needed for television. If residents still use the cable TV service, the adapters must be compatible, and the signals must not interfere. Some systems can share the cable, others cannot. Confirm with the vendor.
The cable is not damaged. Cable that has been painted over, crushed or cut and spliced is a risk.
The closet has room and power. The adapters need a place to live, and each room end needs power, such as an outlet near the wall plate.
Map each outlet and where its cable ends. Walk the building with your maintenance director, and trace what you can.
Ask your IT provider to test two or three representative rooms with matched adapters.
Check the results at different times of day, and with a device that actually needs the connection.
Plan for power at the room end, and for how staff will reset an adapter.
Label each adapter with its room, and add it to your records.
Do not use it for anything that must not fail, such as nurse call, without the vendor's approval.
If a wing is being renovated, or when the walls are open for another reason, install proper network cable then. Coax is a bridge. It makes sense when the cost of opening the walls outweighs the limits of the technology.
If the coax route suits only some rooms, use it for those and run cable for the rest. A mixed plan is fine as long as it is documented.
UnityCare IT evaluates older care buildings room by room and tests existing coax before recommending it. We install and label the adapters, document the results and plan a path to full cabling when it makes sense. Our network and Wi-Fi work covers on-site visits across Oklahoma, Texas and Kansas.
Wi-Fi, switching, firewalls and internet that hold up across a whole facility.
Call or text: 405-285-3845
New customers: start@unitycareit.com
Existing customers: support@unitycareit.com
Service area: based in Edmond, Oklahoma, serving Oklahoma, Texas and Kansas
Hours: Mon–Fri 8 AM–5 PM CT; 24/7 after-hours support