Flood Risk and Ground-Floor Equipment: Raising What Matters

A water heater fails over a weekend. By Monday morning, an inch of water has spread across the floor of the back hallway and into the room where the network equipment lives. The server sits on the floor in the corner, and the paper charts for closed residents are in boxes on the bottom shelf. Both are standing in water.

You do not need a river nearby for this to happen. Burst pipes, sprinkler discharge, clogged drains, roof leaks and heavy rain can all put water at floor level. The fix is often as simple as moving things up.

Walk the building looking down

Take your maintenance director and walk through the places where equipment and records live. For each room, ask what is within a foot or so of the floor. Typical findings include:

A server or a battery backup on the floor of a closet.

Network switches, routers and patch panels mounted low on a wall or sitting on a bottom shelf.

A printer, copier or scanner on the floor.

Power strips lying on the ground with expensive equipment plugged into them.

Boxes of paper records on bottom shelves or directly on concrete.

Backup drives kept on a low shelf.

Equipment in basements, utility rooms, below-grade areas and rooms next to water heaters, laundry or kitchens.

Know your water sources

Floods are not only about weather. Look for the sources of water close to your equipment:

Water heaters, boilers and plumbing in or above the room.

Roof, ceiling and window leaks.

Sprinkler lines.

Floor drains that back up.

Doors at ground level where rain can pool.

Washing machines, kitchen areas and ice machines in neighboring rooms.

If your building sits in a low area or has had water before, ask your insurer or local emergency management about flood risk in your location, and check whether your coverage addresses water damage and equipment.

Inexpensive ways to raise what matters

None of these require a major project.

Move equipment to a shelf or rack. A sturdy wall-mounted rack or a metal shelf a foot or more off the floor is often enough. Make sure whatever you use can hold the weight.

Raise power connections too. A raised server with its power strip lying on the floor is still at risk. Use outlets and surge protection at the higher level.

Put paper records on upper shelves and use lidded plastic bins in place of cardboard boxes for records you keep.

Use pallets or risers for storage rooms that cannot be reorganized.

Choose a better room. If possible, relocate the server closet away from plumbing, exterior walls and low ground. Ask whether a move can be folded into a planned project.

Add a water sensor on the floor near equipment, which can sound an alarm or send a text or email.

Keep a copy offsite. Whatever you raise, backups should live somewhere that a flooded building cannot touch.

Do not forget the less obvious items

Door access panels, phone system equipment, nurse call controllers and camera recorders are often installed low and in odd places. If you are not sure what a box on the wall does, ask your IT provider or vendor before moving it, since moving cabling or nurse call parts without care can break them.

Electrical work should be done by qualified people. If equipment is already wet, do not touch it or turn it on. Cut power at the panel only if it is safe, and call your electrician and your IT provider.

Write it down

Make a short list of the equipment and records you have identified, where each sat, and where it is now. Add it to your emergency plan and your insurance file, and take photos for your records. Revisit it after construction, remodels and equipment changes, since things drift back to the floor over time.

What to do if water arrives

Keep people safe first. Then, in general: shut off power to affected areas if you can do so safely, move dry items up, photograph damage for the insurer, and call your IT provider before restarting anything that was wet. Electronics that dried off may still fail later, so let a professional check them.

How we can help

UnityCare IT can walk your equipment areas with your maintenance director, point out what is at risk, and help rack and relocate network gear and servers safely. We can also install water and temperature sensors and make sure your backups are held offsite, so a wet building does not mean lost records.

Related service

Security monitoring, HIPAA safeguards, backups and staff training for healthcare and small businesses.

Related articles

Keep reading

Contact UnityCare Technologies

Call or text: 405-285-3845

New customers: start@unitycareit.com

Existing customers: support@unitycareit.com

Service area: based in Edmond, Oklahoma, serving Oklahoma, Texas and Kansas

Hours: Mon–Fri 8 AM–5 PM CT; 24/7 after-hours support