Cellular Signal Boosters for Metal-Roofed Care Buildings

A family member steps into the hallway to take a call because the room has no signal, and the charge nurse cannot get a text through from the med room. Out in the parking lot, everyone's phone shows full bars. Inside, the same phones show one bar or none.

The building itself is the culprit. Metal roofing, metal framing, foil-faced insulation and energy-efficient window glass are good at keeping heat out and are also good at keeping cell signal out. A cellular signal booster can help, but it needs some care to buy and install.

Why signal dies indoors

Cellular signals are radio waves, and they lose strength passing through materials. Metal reflects them. Coated glass blocks them. Dense masonry and concrete absorb them. A single-story building with a steel roof may be reasonably good in a hallway near a window and nearly dead in the interior rooms.

The strength of the signal outside matters too. If the roof is in a weak coverage area to begin with, there may be little to boost.

How a booster works

A cellular signal booster has three main parts:

A donor antenna mounted outside, usually on the roof or a mast, which picks up the carrier's signal where it is strongest.

An amplifier inside the building that strengthens that signal.

One or more indoor antennas that rebroadcast the signal through the rooms, connected by coaxial cable.

It works in both directions. It boosts the signal coming down from the tower and also boosts the phone's signal going back up. The outside antenna matters most, because the amplifier can only strengthen what the antenna captures. The antenna should be placed where a phone would get good signal if it were standing at that spot, and away from the indoor antennas.

Limits to understand

It needs a usable outdoor signal. A booster amplifies, but it cannot create coverage that is not there.

Distance and layout limit it. Each indoor antenna covers a limited area, and a long, metal-lined building usually needs several, connected by cabling.

Oscillation. If the outdoor and indoor antennas are too close, the system can feed back on itself, like a microphone near a speaker. Good installation prevents this, and the equipment is designed to shut itself down when it happens.

Carriers differ. A booster built for the main carriers may boost them all, but check that it covers the specific carriers your staff and residents use.

It does not provide data speed where there is none. It can improve calls and texts a lot and data somewhat.

It is not a substitute for emergency radio coverage. Fire departments may have their own requirements for in-building public safety radio coverage. Confirm with your local fire authority and building officials, since the rules vary.

Carrier and regulatory rules

In the United States, consumer signal boosters are regulated by the FCC, and carriers expect them to meet certain standards and to be registered with the carrier. Equipment that is not certified can interfere with the network, and carriers may ask that it be turned off. Ask any seller whether the equipment is certified, and ask your carrier how to register it. Exact rules change over time, so confirm with the carrier and the manufacturer before buying.

Questions before you buy

Is there a usable signal on the roof for each carrier you need?

How many indoor antennas will cover the building, and where do cables run?

Is the equipment certified and registered, and who handles that paperwork?

Who owns the roof penetration, and does it affect your roof warranty?

Would Wi-Fi calling solve the problem for most of the phones in the building?

That last question deserves attention. If your Wi-Fi is solid, phones that support Wi-Fi calling can make calls and texts over it, and that costs much less than a booster. It will not help devices without that feature, so consider it a supplement to a booster rather than a guaranteed replacement.

How we can help

UnityCare IT can survey cell and Wi-Fi coverage inside your building, advise whether a booster, better Wi-Fi or a combination fits, and coordinate cabling with your maintenance director. We work across Oklahoma, Texas and Kansas. For fire-department radio requirements or carrier registration, we will help you ask the right authorities.

Related service

Wi-Fi, switching, firewalls and internet that hold up across a whole facility.

Related articles

Keep reading

Contact UnityCare Technologies

Call or text: 405-285-3845

New customers: start@unitycareit.com

Existing customers: support@unitycareit.com

Service area: based in Edmond, Oklahoma, serving Oklahoma, Texas and Kansas

Hours: Mon–Fri 8 AM–5 PM CT; 24/7 after-hours support